How To Attach A Wooden Awning To A House

Temporarily nail or brace the ledger in place positioned and leveled at the desired height.

How to attach a wooden awning to a house. Remove the shingles or siding in the area identified for the header board. 8 inches in this case. Once the rafters were in place and secured to the 2x4 ledger and the 4x6 beam i measured from the house along the top of one of the end rafters and made a mark at 9 9. Determine the beam size.

They are in essence oversized swatches of water resistant fabric connected to a frame and attached to your house or some other structure. Wall space needed for attaching. Awnings need approximately 6 to 12 inches of open heightwise wall or roof space to be installed. Retractable or fixed a lateral arm retractable awning will allow you to extend your awning without needing extra supports.

These awnings only need one attachment to the house on the wall. A small awning will generally not have these problems. Need some shade in your garden. Attach the ledger with 1 2 inch diameter lag screws or bolts every 16 inches or as specified by local building codes.

Http www primrose awnings co uk for a review three year. They are made out of vinyl canvas or solution dyed acrylic. Re check for level and then drill lag screw or bolt pilot holes through the ledger and into the house s framing. Work from the view back not from the house out.

If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. Choose a roof pitch 3 12 and roof structure 2x6. There are at least three alternative ways to do it. This awning from primrose is just the job available from primrose.

This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. Calculate the sightline clearance height about 6 feet 2 inches in this case. Leave the decking or sheathing in place.