Invisible Fence Receiver Not Working

Because they use a hidden wire that transmits a signal to a collar worn by.

Invisible fence receiver not working. You ll need to diagnose which part or more is not working. What to do if an invisible fence is not working. The receiver is working. Invisible fence systems protect your pets by keeping them in your yard.

That can be expensive. The wall mounted transmitter is. There are three components to dog fencing. Many different brands and models are available but they all work on the same theory that dogs can be trained to avoid crossing.

Try troubleshooting problems with your invisible fence yourself. The transmitter gets plugged into this and the wiring from outside to the transmitter goes through. Make sure the static correction level on the receiver collar is set at 2 or above. The batteries are good.

An invisible fence is less expensive than traditional fences because you don t have to buy materials or hire someone to build the fence. This result tells you. I am using the term invisible fence to refer to any containment system that includes a border created by a buried wire a transmitter and a receiver collar that can produce audible signals and electric shocks. It will not work that high off the ground since the signal is not adjusted to activate the collar much above your dog s neck level.

You can buy batteries one at a time or we recommend keeping your pet on an annual power cap plan. However if your invisible fence stops working you may have to call the company to troubleshoot. Next put a small piece of wire or paperclip into the jacks where the wires had been connected. To do this turn off the power then disconnect the two dog fence wires from the invisible fence transmitter.

If the alarm stops the fence transmitter is working and you have a break somewhere out in the yard. If the test light flashes your collar is working and you should try check the following. Electronics usually this consists of a transmitter that is typically mounted on a wall a receiver collar that the dog wears and sometimes a surge protector that is plugged into an outlet. Take the test light tool and place it on the receiver collar and walk out to the boundary of the containment system.

This creates a mini loop. At invisible fence brand we welcome your questions. Check the fit of the receiver collar on your pet.