How Tight To Nail Vinyl Siding

Do not drive nails tight.

How tight to nail vinyl siding. Do not drive the head of the fastener tightly against the siding nail hem. Between nail head and vinyl. Secure interlocking panel design provides a tight fit with no insulation gaps. Prodigy one piece insulated siding system.

Drive nails straight and level. Learn more on proper nailing for vinyl siding installation how to install vinyl siding. Also learn the right way to hang siding with insulation in mind. Following is a discussion of how to do both.

Allow approximately 1 32 0 8mm clearance the thickness of a dime between the fastener head and the vinyl. The problem should be easy to diagnose. To install vinyl siding to the soffit and fascia area on your home nail lengths of j channel along the inner edge of the fascia leaving the nail heads out about 1 32 to 1 16 of an inch. Integrated 1 thick eps rigid foam insulation nominal helps reduce utility costs and reinforces the siding.

Center nails in slots. An expert guide on the best way to nail vinyl siding either by hand or using a power nailer. For the best results leave at least 1 16 inch between the nail head and the siding to give it some room to grow. Do not nail to the extreme right or left of nail slot in siding panel.

Vinyl siding tends to expand and contract considerably with temperature changes. Vinyl siding can either be nailed by hand with a hammer or by a power nailer. This will permit expansion and contraction as well as prevent dimpling which causes waves in siding. Tight nailing screwing or stapling will cause the vinyl siding to buckle with changes in temperature fig.

Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1. Next measure and cut the siding to fit the measurements of your soffit and push each panel into the j channel. Allow approximately 1 16 in.