How Many Turns On Awning Spring

New dometic heavy duty springs installed on a 19 8500 awning set at 8 turns do not retract the awning without me pushing it up.

How many turns on awning spring. Adjust awning tension adjust spring tension rv awning how to adjust the tension on an rv awning awning tighting adjustments how to adjust spring tension on rv awning rv awning tension loose adjust rv awning spring rv awning spring tension. Here s the recommended number of turns but keep in mind the older the assembly the more likely you ll have to add one or two more. Reinsert the end cap into the awning arm and install the bolt. Roger it depends on the age of the torsion assemblies and if you add the windings while the awning is in the travel position or the extended position.

Only rotate the legs one or two turns at a time and don t do more than 4 or 5 total. Repeat the process with the rear support arm but rotate it clockwise rather than counterclockwise one turn. Severe injuries can result from the rapid spin off of the top casting. Support the roller bar the part of the assembly that holds the awning when it s retracted at its center with a 6 foot ladder or other suitable device.

The torsion spring will be wound with 8 eight more turns in this position and is extremely dangerous. This however will still depend on the model of the rv awning that you own. The unwinding can also be done while standing on the ground and the awning fully extended and the opposite side rafter locked in place. Remember you are adding the initial turns to the turns that the awning gets as it unrolls.

Attach the vice grips to the new ratchet assembly and rotate as many turns as noted in step 6. Have your assistant hold and steady the support bar you re not working with. It s best to check your rv awning manual to determine the number of turns you ll need winding up your spring. See our channel page for link the home on the road series consists of three 2 dvd.

You do not need to put the screws back in. If not then repeat the previous steps. Rotate the support arm at the front end of the awning counterclockwise one complete turn. Rotate the support bar one turn to tighten the spring.

If you are satisfied move on. How tight can i safely read more. Roll the awning back up to observe how tight it is. Extended 17 turns travel position 9 turns.